WEEK 7 ( led cube process and casing )

FIGURE 1

FIGURE 2

FIGURE 3

FIGURE 4

FIGURE 5

AIM

• To solder all of the LED into a cube form.
• To make a hole on PCB board.
• To etching a new PCB LED circuit.

RESULTS

• At the figure 1, after the hole at the PCB board had been made, the five layer of LED need to be plant on the sponge materials. At the right side of the picture, steel has been used to make the connection of the LED in series direction. The figure on the left side shown the 3D view and for the right side shown the upper layer of the cube.

• At the figure 2, cathode terminal need to be solder as a base of the cube. The picture shown the step to make it.

• At the figure 3,  after all of the cathode terminal solder done, the cube of the LED will look as a picture above. The 3D view will be seen on the 45 degree angle.

• At the figure 4,  the casing of the project will look as a picture above. The function of the casing is to make the LED look more brightness when turn on.

• At the figure 5,  after all of the process to make LED in cube shape have done, final view of 3D LED Cube is look like the picture above.

PLAN FOR THE NEXT WEEK

• To testing LED Cube operation.
• To make a wiring on the cathode terminal at the PCB Board.
• To run a program testing.
• Project demo